AMX AXCENT3 AND AXCENT3 PRO INTEGRATED AXCESS SYSTEM User Manual

Axcess Programming
20
Axcent
3
and Axcent
3
Pro Integrated Axcess Controllers
PROGRAM Port Commands (Cont.)
SET BASE DEVICE
NUMBER
Master and
Slave
Sets the AXlink base device number on the controller’s RS-232 port
1. Subsequent ports on the controller are incrementally set. If the
device number is 1, the controller becomes an AXlink bus master,
and if the device number is set to 2-xxx, the controller becomes a
slave.
Syntax:
SET BASE DEVICE NUMBER <Device>
Variables:
Device = 1 - 238
SET DATE Master Changes the date in the controller.
Syntax:
SET DATE
SET TIME Master Changes the time in the controller.
Syntax:
SET TIME
SHOW DEVICE Master Displays a list of all devices present on the AXlink bus.
Syntax:
SHOW DEVICE
SHOW INPUT OFF Master Sets Show Input mode off.
Syntax:
SHOW INPUT OFF
SHOW INPUT ON Master Sets Show Input mode on.
Syntax:
SHOW INPUT ON
SLOT Master The active controller returns its slot number.
Syntax:
SLOT
SYSTEM RESET Master The controller stops communication on AXlink for 2 seconds and
then restarts. The system program then restarts according to the
Define_Start section.
Syntax:
SYSTEM RESET
TIME Master The controller returns the time in its internal clock.
Syntax:
TIME
VERSION Master and
Slave
Displays current software version of the controllers.
Syntax:
VERSION

AMX AXCENT3 AND AXCENT3 PRO INTEGRATED AXCESS SYSTEM Specifications

General

Brand	AMX
Model	AXCENT3 AND AXCENT3 PRO INTEGRATED AXCESS SYSTEM
Category	Controller
Language	English