Axcess Programming
19
Axcent
3
and Axcent
3
Pro Integrated Axcess Controllers
PROGRAM Port Commands (Cont.)
OFF Master Turns the device and channel numbers off.
Syntax:
OFF[Device, Channel]
Variables:
Device = 1 - 255
Channel = 1 - 255
Example:
>OFF [52,1]
Turns channel 1 on device 52 off.
ON Master Turns the device and channel numbers on.
Syntax:
ON [Device, Channel]
Variables:
Device = 1 - 255
Channel = 1 - 255
Example:
>ON [25,1]
Turns channel 1 on device 25 on.
PAS S Master Syntax:
PASS <Device Number>
This command communicates across the AXlink bus to external
devices. When the PASS mode is enabled, all characters sent to the
controller are passed along to the specified device, and all charac-
ters received from the device travel to the controller and then out of
the card’s port. To exit from the PASS mode, type the following while
holding down the <Shift> key (<ESC> is the Escape key):
++ <Esc> <Esc>
PULSE Master Pulse the device and channel numbers.
Syntax:
PULSE [Device, Channel]
Variables:
Device = 1 - 255
Channel = 1 - 255
Example:
>PULSE [16,1]
Pulses channel 1 on device 16.
SEND_COMMAND Master Send commands to the specified device. Refer to the device’s litera-
ture for programming.
Syntax:
SEND_COMMAND <Device>, String
Variables:
Device = 1 - 255
SEND_STRING Master Send strings to the specified device. Refer to the device’s literature
for programming.
Syntax:
SEND_STRING <Device>, String
Variables:
Device = 1 - 255
To Next Page
Loading...
Need help?
General
