Enova DGX DXLink™ Fiber Boards
113
Hardware Reference Manual – Enova DGX 100 Series Digital Media Switchers
* Duplex boards/units support bidirectional control over fiber. Simplex boards/units do not support EDID transfer and control
transport (such as Ethernet, USB, IR, and Serial Control) over fiber; although when used as part of a complete Enova DGX solution,
control can be provided if a supplemental independent network connection is used (see page 124).
** The scaler on the corresponding output board or DXLink Fiber RX must be set to Bypass mode using CTA-861 formats and the
resolution is 1080p,60 or less.
USB (HID) Transport Use the Enova DGX Digital Media Switcher in conjunction with DXLink Transmitters
and Receivers (twisted pair and/or fiber). Connect a DXLink Transmitter to a PC
and a DXLink Receiver to a keyboard and mouse; the system then emulates
commands from the Receiver back to the PC.
A list is available of HID devices which have been tested and found to be
working well with the latest firmware (see “DXLink - HID supported Devices”
on the DXLink Fiber Receiver’s product page at www.amx.com).
CEC Support None
ICSP, TCP/IP, USB, IR, Control Management Control distribution is managed by the Enova DGX on-board NetLinx NX Master
and Ethernet switch.*
Fiber Transceiver Type 10G SFP+
Connectors 4 LC Duplex Fiber ports (used on both Duplex and Simplex boards) conforming to
ANSI TIA/EIA 604-10 (FOCIS 10A)
• On the DXLink MM / SM Duplex input and output ports, both receive and
transmit portions of the SFP+ module are active.
• On the DXLink MM / SM Simplex output ports, only the transmit portion of the
SFP+ module is active.
• On the DXLink MM / SM Simplex input ports, only the receive portion of the
SFP+ module is active.
Fiber Cable Types and Supported Length • Single mode models, duplex/simplex – 9/125 μm @ 6.21 miles (10 km)
• Multimode models, duplex/simplex – OM3 50/125 μm @ 984 ft. (300 m)
Optical Wavelength • Single mode – 1310 nm
• Multimode – 850 nm
Single Mode Optical Budget • 7.4 dB (typical) between DXLink Fiber transceivers
• Optical Modulation Amplitude (OMA): -5.2 dBm (min.)
• Optical Modulation Amplitude (OMA) Sensitivity: -12.6 dBm (typical)
Single Mode Optical Transceiver
Mean Output Power
-8.2 dBm to 0.5 dBm (average power)
Multimode Optical Budget • 6.8 dB (typical) between DXLink Fiber transceivers
• Optical Modulation Amplitude (OMA): -4.3 dBm (min.)
• Optical Modulation Amplitude (OMA) Sensitivity: -11.1 dBm (typical)
Multimode Optical Transceiver
Mean Output Power
-1 dBm (average power)
DXLink Fiber Input Board Propagation Delay 5 μs
DXLink Fiber Output Board Propagation Delay 5 μs
Safety Certifications Class 1 Eye Safe per requirements of IEC 60825-1 / CDRH
DXLink Fiber, Duplex and Simplex – Specifications
specs - fiber cable
types and supported
length
To Next Page
Loading...
