EasyManuals Logo

Analog way SmartMatriX2 User Manual

Analog way SmartMatriX2
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
22
4.8.3 Video output
The HDBaseT input and output connectors of the  can manage the Ethernet
passthrough. A specic LAN over HDBaseT connector is available on the  to be connected to
the dedicated network.
The HDBaseT LAN cannot be used to manage the device.
4.8.3 HDBaseT LAN interface
Associated to each HDBaseT output connectors, the 5-pin MCO connector can passthrough the one-way
InfraRed and the Bidireconal Serial RS232 signals to the HDBaseT output interface.
The pins #1 to #3 are used for the HDBaseT Serial RS232 connecon, respecvely for the transmission (TX),
the recepon (RX) and the Ground RS232 signals.
The pins #4 and #5 of the MCO connector are dedicated for the HDBaseT IR signal, respecvely for the
recepon (RX) and for the Ground signals.
Please note that some IR sensors could have a low power signal which could not be compable with the
expected IR input characteriscs of the Midra™. In case of issue, make sure to use professional IR controller.
4.8.4 IR and SERIAL HDBaseT interface

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Analog way SmartMatriX2 and is the answer not in the manual?

Analog way SmartMatriX2 Specifications

General IconGeneral
BrandAnalog way
ModelSmartMatriX2
CategoryMedia Converter
LanguageEnglish

Related product manuals