EasyManuals Logo

Analog way SmartMatriX2 User Manual

Analog way SmartMatriX2
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #55 background imageLoading...
Page #55 background image
55
It is strongly recommended reseng all of the default values of your SmartMatriX² unit before seng up your
shows and events. This will help eliminate confusion caused by unneeded sengs from a previous operator.
To do so, press the  buon and select Control in the menu by rotang the corresponding knob.
Then press the ENTER buon to enter the  sub-menu. Select Default Values by rotang the scroll
knob, and press the ENTER buon to enter your choice to restart your SmartMatriX² with its factory sengs.
This operaon should take approximately 30 seconds.
Analog Way engineers have developed a handy, user friendly way of idenfying machine status on the front
panel, via the use of color codes on the buons of the machine. All new Analog Way machines use the same
codes, for quick recognion of the status of any device of the range, at any given me.
For the SmartMatriX², buon color codes are as follow:
• Sources on the Program output are indicated in red when acve,
• Sources on the Preview output are indicated in green when acve,
Buons in the layer secon turn red or green, depending on whether the selected layer is acve in
respecvely the Program or Preview window,
• menu buons are indicated in green,
Selecng a buon with an available source or funcon will cause that buon to blink green on the preview,
or red once it is on the Program output,
TAKE buon reacts as follows:
- If take funcon is available, the buon will appear in green.
- When the take funcon is acve, it will light up red.


8.1.4 Reseng default values

#1 = Source is on the Program output
#2 = Freeze enable

Blinking red:
Blinking green:
#1 = Source is on Preview
#2 = Funcon available for modicaon
#3 = Current output on Matrix mode
Layer/source selected or is currently acve
on the Program output
Layer/source selected or is not currently
acve on the Program output
8.2 
Plug your sources using the 4 mul-plug inputs, 2 HDMI®Inputs or 4 3G/HD/SD-SDI inputs.
Be sure that all connectors are rmly aached using all available locking screws.

To set up your inputs automacally:
You can also do it manually on each input# using the ENTER and the Knob buon and set up the inputs type
one by one.
You can also check your actual input conguraon using the cong status: 


Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Analog way SmartMatriX2 and is the answer not in the manual?

Analog way SmartMatriX2 Specifications

General IconGeneral
BrandAnalog way
ModelSmartMatriX2
CategoryMedia Converter
LanguageEnglish

Related product manuals