Anderic RRUR01 - Learning Function; Programming Learned Keys; Managing Learned Keys; Delete Individual Learned Key

on, release the key.
2. Input code “9 0 0”,
3. Press the key you want to disable the punch-through for; mode light blinks 2 times to
confirm.
Learning function
Learning allows for programming individual keys using your existing remotes codes.
1. Press and hold the mode key (e.g. TV) you wish to program for about 3 seconds until the
mode light remains on, release the mode key.
2. Press and release [MENU] key, the mode key blinks slowly, remote is now in learning mode.
3. Press and release key you want learned, mode light now remains on.
4. Align both remotes by pointing them at each other, with a distance of about 2 inches apart
with IR LEDs directly aligned.
5. Press and remain holding the corresponding key on the target remote control until mode light
blinks 3 times, then flashes slowly; means code learned successfully, continue to step 6.
a. If unsuccessful - mode light flashes 2 times quickly & exits from leaning mode. This
may indicate not enough memory space, please delete some learned keys. Please start
over from step 1.
6. Repeat steps 3-5 to learn all your needed keys while model light blinks slowly, then
7. Press mode key (e.g. TV) to save and exit.
Delete individual learned key
1. Press and hold the mode key (e.g. TV) you wish to program for about 3 seconds until
the mode light remains on, release the mode key.
2. Press and release [MENU] key, the mode key blinks slowly, remote is now in
learning mode.
3. Press and hold the key you want to delete learned code from,
a. If successful - mode light blinks 3 times, remote saves and exits.
b. If unsuccessful - mode light blinks 2 times and exits.
4. Repeat steps 1-3 to delete other learned keys.
Delete all learned keys under a single device
1. Press and hold the mode key (e.g. TV) you wish to program for about 3 seconds until
the mode light remains on, release the mode key.
2. Press and release [MENU] key, the mode key blinks slowly, remote is now in
learning mode.
3. Press and hold the mode key you want to delete all learned keys from (e.g. TV) until
the mode light blinks 3 times and exits.
Delete all learned keys from all devices
1. Press and hold the mode key (e.g. TV) you wish to program for about 3 seconds until
the mode light remains on, release the mode key.
2. Input code "9 9 8 8", mode light blinks 2 times slowly to confirm and exits.
Backlight adjustments
Toggle backlighting on/off
1. Press and hold any mode key (e.g. TV) for about 3 seconds until the mode light remains on,
release the mode key.
2. Input code "9 9 8 5".