12
Luna/Alba | EN
Setting the portafilter support and spout
Adjust the portafilter support (12) to the size of the portafilter of your espresso
machine as described in the following.
1. Ensure that the grinder is switched off (on/off switch(7) in the 0 position).
2. Use a screwdriver to unscrew the two screws (10) for adjusting the portafilter
support (left and right) a few turns (counterclockwise direction).
The portafilter support (12) moves down to the stop.
3. Insert the portafilter support in the portafilter intake(14).
4. Push the portafilter support upwards until the portafilter fits exactly between the
portafilter support and the portafilter intake.
If the supplied portafilter support does not fit, contact your supplier (see
“Maintenance and service” section).
5. Hold the portafilter support in position and use a screwdriver to tighten up the
two screws for adjusting the portafilter support (left and right) (clockwise direc-
tion).
6. Push the spout guide (6) upwards or downwards in the lock to align the spout(15)
in the optimum position for your portafilter. Align the spout in such a way that
the coffee grounds fall out of the spout into the center of the inserted portafilter.
Reset the spout after every grinding degree adjustment and every change
of the type of espresso beans.
To Next Page
Loading...
