ANFIM Luna - Safety Information

7
Luna/Alba | EN
Safety information
WARNING !
Risk of electric shock!
Improper use, incorrect electrical installation, or a voltage that is too high can all lead
to electric shock.
» Connect the grinder only if the supply voltage of the socket complies with the
information indicated on the type plate.
» Connect the grinder only to an easily accessible socket to allow you to disconnect
it quickly from the power supply in the event of a malfunction.
» Do not use the grinder if you notice any visible damage or if the power cable or
plug is faulty.
» If the grinder’s power cable is damaged, it must be replaced by the manufacturer
or by qualified personnel in order to avoid hazards.
» Only connect the grinder to a power supply with a 16A-slow fuse. In the event
that the power connection at the installation site of the grinder is not secured in
this way, have a 16 A-slow back-up fuse fitted by a qualified electrician.
» Always switch the grinder off (on/off switch in the 0 position) before you remove
the power plug.
» Install the grinder only in locations where its use can be supervised by trained
personnel.
» Do not operate the grinder at altitudes above 2,000 meters.
» Do not immerse the grinder, the power cable or the power plug in water or any
other liquids.
» Do not clean the grinder with a water jet.
» Do not clean the grinder with compressed air (e.g. with a compressed-air blow
gun).
» Never touch the power plug with wet hands.
» Never unplug the power plug from the wall socket by pulling on the power cable;
always grip the power plug.
» Never carry the grinder by its power cable.
» Keep the grinder and power cable/power plug away from open flames and hot
surfaces.
» Do not position the power cable in such a way that it could create a tripping
hazard.
» Do not bend the power cable and do not place it over sharp edges.
» Use the grinder in indoor areas only. Never operate the grinder in damp areas
or in the rain.