ANFIM Luna - Cleaning procedures; Cleaning the casing

19
Luna/Alba | EN
Cleaning the surface underneath the grinder
1. Switch off the grinder (on/off switch(7) in the 0 position) and pull the power
plug(9) out of the socket.
2. Lift the grinder by its casing with both hands and place it on another surface that
is clean.
3. Clean the surface underneath the grinder and the underside of the grinder with
a damp cloth and then wipe the surface dry.
The surface underneath the grinder must be dry and free of oil and grease.
4. Place the grinder back onto the cleaned surface.
Cleaning the casing
Clean the casing as required, but at least once a week or once per 10 kg
of ground espresso beans.
1. Switch off the grinder (on/off switch(7) in the 0 position) and pull the power
plug(9) out of the socket.
2. Clean the following parts of the grinder with a brush:
• Spout(15)
• Portafilter(14)
• Trigger switch(13)
• Portafilter support(12)
• Screws (10) for adjusting the portafilter support (left and right).
3. Remove the drip tray(11).
4. Clean the housing and the removed drip tray with a damp cloth and then wipe
them dry.
5. Replace the drip tray after cleaning.