To Next Page

To Previous Page

Water Hardness: Allows you to set the parameter of hardness of water. This determines

the quantity of chemicals and water used during washing,

Update SW, FW: This selection start the process of updating the software on the CPU (1a)

and the firmware on the power board.

Before performing the upgrade the USB stick (recommended max. size 4GB) should be

inserted into the connector (the stick must be formatted FAT or FAT32 and contain a

directory "AngeloPo" with all the necessary files inside).

How to update software and firmware

To update the software and firmware, proceed as follows:

- Enter the service menu

- Insert the key into the USB connector

- Select "Update SW, FW"

- Wait until the end of the procedure and follow the instructions that appear on the

display

- During this procedure the message “turn off and on the oven” will appear. This has

to be done by the green power switch. Attention! Don’t remove the USB Stick! (if you

switch from version 1.x to 2.x, the system will require a second reboot, again without

removing the USB stick!)

- Remove the USB stick only when the complete update has been finished (when the

main menu is displayed)

Update parameters: This selection starts the procedure for updating parameters of the

boards without the USB stick. It is performed normally when you change the power

board 2 or the CPU 1a in order to align the parameters of the boards. To activate the

update enter the password FA53.

How to update the parameters (SW and FW alignment)

This procedure allows the user to align the parameters of the boards after replacing the

CPU board or power board. The procedure is performed after replacing the card, as

follows:

Angelo Po FX Series User Manual

Questions and Answers: