Copyright by Servizio Clienti ANGELO PO Spa
38
3 ) Press the START / STOP in order to start the update procedure ( “-“ will run on the
lower display)
4) The update must includes the CPU and the power board, no key is activated during the
update.
5 ) After the update the display turns off again.
How to configure the type of oven
The setup process of the oven must be done after replacing one of the following
components: CPU board, power board, inverter, combustion and fan control board.
It is required in order to make all the boards communicate and to select the correct
operating parameters of the oven.
Operate as follows:
o With the oven on and in standby mode hold down (simultaneously) the keys
"convection" and "reset" for 4 seconds to enter the configuration screen.
o Select using the knob the model of the oven in the display and confirm
pushing the knob.
o Wait for the end of the configuration process and compare what appears on
the display with the table below.
o If the configuration is incorrect check the connections between the boards
and press the knob to repeat the configuration.
o If the configuration is correct press the "start / stop" button to exit.
To Next Page
Loading...
Need help?
General