Animo OptiFresh Bean - Display Messages; Malfunctions

EN 87 2015/02 Rev. 1.0
OptiFresh Bean
6.2 Display messages
6.3 Malfunctions
Problem Possible cause Correction
Out of order boiler filling When used for the first time: boiler
is still empty, boiler is being filled.
No action required.
Out of order boiler filling Boiler is not filling up or is filling up
too slowly. After 60 seconds the dis-
play will show "E3 Level error".
Check the water pressure. Turn
the water supply tap completely
open. Check the connection tube
for any kinks. Switch the
machine off and on again.
Out of order boiler heating The boiler temperature is too low
because too much water is used.
Wait until the boiler temperature
has reached the correct level.
Out of order drip tray full Drip tray is full. Empty the drip trays.
Out of order waste bin full Waste bin full. Empty the waste bin.
Out of order waste bin is
missing
Waste bin is missing. Check the waste bin.
Out of order door open The door is open. Close the door or use the door
pin.
Out of order stand-by The machine is on standby. Remove the standby mode in the
configuration menu.
Close door The door is not closed correctly. Close the door.
Rinse The rinsing program has not been
carried out.
Carry out the rinsing program.
Refer to 5.2.4.
Clean The cleaning program has not been
carried out.
Carry out the cleaning program.
Refer to 5.2.5.
Change brewer filter The brewer filter needs to be
replaced by a clean brewer filter.
Refer to 5.2.6.
Service boiler The boiler needs service. Contact the dealer or service
engineer.
Service brewer The brewer needs service. Contact the dealer or service
engineer.
Problem Possible cause Correction
The machine does not work. Broken fuse. Check fuses.
The machine is switched off. Switch on the machine.
Broken cable. Check the power cable.
The machine does not
reponse.
The machine is in standby. Switch off the standy mode.
Bad product taste. The canister is empty. Fill the canister.
The canister is incorrectly posi-
tioned.
Position the canister correctly.
The outlet of the canister is
blocked.
Clean the outlet of the canister.