Page 13 of 28
4 Instructions for Use
Remove the cable tie and unravel the cordset before operation.
DO NOT run the power cord under the stand
4.1 Head Tilt
The Fan Head can be adjusted Up and Down so as to blow air at the
required angle.
Turn off and unplug prior to adjusting.
To adjust, grasp the Fan Grills and tilt the head either upward or
downward to your desired angle.
4.2 Height Adjustment
The height of the fan can be adjusted.
Unscrew the Height Adjustment Locking Screw (Anticlockwise) on the back of the stand
post, slide the inner post up or down and then tighten the Height Adjustment Locking
Screw (Clockwise) again to lock in place.
To Next Page
