Page 19 of 28
• Press the “ON/OFF” button on the remote control once, or the knob on the fan control
panel. The “Fan” indicator light and Speed display number will illuminate. The fan will
start to spin at Speed setting 5.
• Press the “SPEED” button on the remote control, or rotate the knob on the fan control
panel one notch and the speed will increase to number 4.
• Repeat above steps to cycle the speed up to speed 8 and then onto speed 1 then 2
etc.
• To turn the fan off, press the “ON/OFF” button on the remote control or press the knob
on the fan control panel.
8.2 Fan Modes
The Fan has three modes being: Normal, Nature, and Sleep.
With the Fan running in “Normal” mode (neither of the Sleep Mode or Nature Mode
Indicator lights illuminated), press the “MODE” button on the remote control or Fan
control Panel and the mode will change to “Nature” mode (The Nature Mode indicator
light will illuminate).
Press the “MODE” button again and the mode will change to “Sleep” mode
(Nature
Mode Light will turn Off and the Sleep Mode indicator light will illuminate).
Press the “MODE” button again, and it will cycle back to “Normal” mode. (both of the
Sleep Mode and Nature Mode Indicator lights will turn off)
8.2.1 Normal Mode
The “Normal” Mode is set by default when the unit is first turned on. The wind remains
a constant flow.
8.2.2 Nature Mode
The “Nature” mode creates variable Wind Patterns so as to simulate the variable winds
that you would experience outdoors.
In this mode the speed of the fan continually cycles through a mixed selection of low,
medium, high and off in set intervals.
Depending on which Fan Speed is selected, the wind pattern will be different.
8.2.3 Sleep Mode
In “Sleep” mode, when the fan is set to either Medium or High Speeds, the fan speed
will drop a speed level after approximately 30 minutes.
After approximately a further 30 minutes, the fan will automatically drop down to a lower
fan speed.
The fan will continue to run in a Low Speed until manually turned off.
Note: To have the fan automatically turn off at your desired time in this mode, use the
“Timer” function to select the auto off timer.
To Next Page
