3-4 Commands Command Directory
3-44 PN: 10370-10374 Rev. F MG369xC GPIB PM
FR0
Description: Disable random waveform access of the FM waveform.
Serial command: 0x04b4
Functional
Category: MODULATION
Example: FR0
Related
Commands: FLW, FMO, FR1
Front Panel Key: NA
FR1
Description: Enable random waveform access of the FM waveform.
Serial command: 0x04b5
Functional
Category: MODULATION
Example: FMO
Related
Commands: FLW, FMO, FR0
Front Panel Key: NA
FRS <value> <unit>
Description: Opens the frequency scaling reference multiplier parameter.
Permits setting the frequency scaling reference multiplier value. This command affects
all entered and displayed frequencies, but does not affect the output of the instrument.
Functional
Category: CONFIGURATION
Value: 0.1 to 14
Units: TMS
Example: FRS 3 TMS
Sets the frequency scaling reference multiplier to 3.
Front Panel Key: System | Config | RF > | More > | Frequency Scaling
FUL
Description: Selects the full range sweep mode.
Selects a full band frequency sweep from the MG369xCs low frequency limit to its high
frequency limit.
Functional
Category: SWEEP
Example: SSP; FUL, AUT
Turns on auto triggered step sweep, full range.
Output Command: OFL returns the low-end frequency value (in MHz) to the controller
OFH returns the high-end frequency value (in MHz) to the controller.
Front Panel Key: Frequency | Step Sweep | Frequency Control > | Full
Frequency | Manual Sweep | Frequency Control > | Full
To Next Page
Loading...
Need help?
General
