Programming with GPIB Commands 2-22 Miscellaneous Commands
MG369xC GPIB PM PN: 10370-10374 Rev. F 2-61
2-22 Miscellaneous Commands
Table 2-23 is a list of miscellaneous command mnemonic codes that do not fit into any of the other
classifications. These commands provide the following operations:
• GPIB Address Change
• CW Ramp
• Secure Mode
• Returning the MG369xC to local control
• Instrument Reset
• Serial Number Entry
• Phase offset control
Table 2-23. Miscellaneous Commands
Mnemonic
Code Function
ADD Opens the GPIB address parameter.
Programming Example:
Programming “ADD 13 ADR“ changes the instrument GPIB address to 13.
CS0 Turns off the CW ramp.
CS1 Turns on the CW ramp.
DS0 Turns on the secure mode.
DS1 Turns off the secure mode.
MR Performs a master reset of the instrument by setting all of the instrument parameters to factory
default.
PS0 Turns off the Phase Offset.
PS1 Turns on the Phase Offset.
PSZ Zeros the Phase Offset display.
RL Returns the instrument to local (front panel) control.
RST Resets the MG369xC to its default settings. See the note below.
SNR Enter the instrument serial number.
Note
Sending the RST command clears the current instrument setup. If this setup is needed for future
testing, save it as a stored setup (Section 2-12 “Stored Setup Commands” on page 2-34) before
sending RST.
To Next Page
Loading...
Need help?
General
