A-3 Alphabetical Listing
A-2 PN: 10370-10374 Rev. F MG369xC GPIB PM
A-3 Alphabetical Listing
Table A-1. Alphabetical GPIB Command List (1 of 13)
Command Code Function Page
*IDN? Requests device identification. 3-2
ACW Activates the currently open frequency parameter as CW. 3-2
AD1 Selects F1-F alternate frequency sweep. 3-2
AD5 Selects F5-F alternate frequency sweep. 3-3
AD6 Selects F6-F alternate frequency sweep. 3-3
ADD Opens the GPIB address parameter. 3-3
ADP1 Opens the internal AM % depth parameter. 3-4
ADP2 Opens the internal AM dB depth parameter. 3-4
ADR GPIB address terminator. 3-4
AF1 Selects F1-F2 alternate frequency sweep. 3-5
AF3 Selects F3-F4 alternate frequency sweep. 3-5
AFU Selects full range alternate frequency sweep. 3-5
AL0 Sets the alternate frequency sweep RF output to L0. 3-6
AL1 Sets the alternate frequency sweep RF output to L1. 3-6
AL2 Sets the alternate frequency sweep RF output to L2. 3-6
AL3 Sets the alternate frequency sweep RF output to L3. 3-7
AL4 Sets the alternate frequency sweep RF output to L4. 3-7
AL5 Sets the alternate frequency sweep RF output to L5. 3-7
AL6 Sets the alternate frequency sweep RF output to L6. 3-8
AL7 Sets the alternate frequency sweep RF output to L7. 3-8
AL8 Sets the alternate frequency sweep RF output to L8. 3-8
AL9 Sets the alternate frequency sweep RF output to L9. 3-9
AM0 Turns off the internal or external AM function. 3-9
AM1 Turns on the external AM function in linear mode. 3-9
AM2 Turns on the external AM function in log mode. 3-10
AM7 Turns on the internal AM function in linear mode. 3-10
AM8 Turns on the internal AM function in log mode. 3-10
AMI Turns on the AM measurement mode. 3-10
AMO Turns off the internal AM function generator if it is on. 3-11
AMR Opens the internal AM rate parameter. 3-11
AMS Opens the external AM %/V sensitivity parameter. 3-11
AMW(x) Selects the internal AM waveform. 3-12
ASD Opens the external AM dB/V sensitivity parameter. 3-13
AT0 Deselects ALC step attenuator decoupling. 3-13
AT1 Selects ALC step attenuator decoupling. 3-13
ATT(xx) Sets the step attenuator value to xx (times 10 dB). 3-14
AUT Selects automatic sweep triggering. 3-14
BPN Selects -3.3V for retrace and bandswitch blanking outputs. 3-14
To Next Page
Loading...
Need help?
General
