Command Directory 3-4 Commands
MG369xC GPIB PM PN: 10370-10374 Rev. F 3-3
AD5
Description: Selects F5-F alternate frequency sweep.
Selects an alternate symmetrical frequency sweep around F5. The width of the sweep is
determined by the DF frequency parameter. If the MG369xC is sweeping when AD5 is
received, the instrument’s output will alternate between the commanded sweep and the
sweep being executed.
Functional
Category: SWEEP
Example: SSP; SF1; F5 5 GH; DLF 1 GH; AD5
Sets step sweep F1-F2 and alternate step sweep F5-dF.
Related
Commands: F5, DLF, DFF, DFM
Front Panel Key: Frequency | Step Sweep | More > | Alternate Sweep > | Alternate Range | F5-dF
AD6
Description: Selects F6-F alternate frequency sweep.
Selects an alternate symmetrical frequency sweep around F6. The width of the sweep is
determined by the DF frequency parameter. If the MG369xC is sweeping when AD6 is
received, the instrument’s output will alternate between the commanded sweep and the
sweep being executed.
Functional
Category: SWEEP
Example: SSP; SF1; F6 5 GH; DLF 1 GH; AD5
Sets step sweep F1-F2 and alternate step sweep F6-dF.
Related
Commands: F6, DLF, DFF, DFM
Front Panel Key: Frequency | Step Sweep | More > | Alternate Sweep > | Alternate Range | F6-dF
ADD <value> <unit>
Description: Opens the GPIB address parameter.
Permits changing the instruments GPIB address. The address must be between 1 and 30
and must be terminated with ADR. Once the address is changed, the MG369xC will no
longer respond to the old address. The signal generators default address is 5.
Functional
Category: MISCELLANEOUS
Value: 1-30
Units: ADR
Example: ADD 6 ADR
Changes the instrument GPIB address to 6.
Front Panel Key: System | Config | GPIB > | GPIB Address
To Next Page
Loading...
Need help?
General
