To Next Page

To Previous Page

3-4 Commands Command Directory

3-6 PN: 10370-10374 Rev. F MG369xC GPIB PM

AL0

Description: Sets the alternate frequency sweep RF output to L0.

Causes the preset (or previously set) L0 RF power level to be output during the alternate

frequency sweep. The command will also deselect any other previously programmed

alternate sweep power level. The command does not open the L0 power level parameter

for data entry. Use the parameter entry commands, XL0 or L0, to enter a new power

level.

Functional

Category: POWER LEVELING

Example: SSP; SF1; AF3; XL0 2 DB; AL0

Sets step sweep F1-F2, alternate step sweep F3-F4, and alternate level L0.

Commands: L0, XL0

AL1

Description: Sets the alternate frequency sweep RF output to L1.

Causes the preset (or previously set) L1 RF power level to be output during the alternate

frequency sweep. The command will also deselect any other previously programmed

alternate sweep power level. The command does not open the L1 power level parameter

for data entry. Use the parameter entry commands, XL1 or L1, to enter a new power

level.

Functional

Category: POWER LEVELING

Example: SSP; SF1; AF3; XL1 2 DB; AL1

Sets step sweep F1-F2, alternate step sweep F3-F4, and alternate level L1.

Commands: L1, XL1

AL2

Description: Sets the alternate frequency sweep RF output to L2.

Causes the preset (or previously set) L2 RF power level to be output during the

alternate frequency sweep. The command will also deselect any other previously

programmed alternate sweep power level. The command does not open the L2 power level

parameter for data entry. Use the parameter entry commands, XL2 or L2, to enter a new

power level.

Functional

Category: POWER LEVELING

Example: SSP; SF1; AF3; XL2 2 DB; AL2

Sets step sweep F1-F2, alternate step sweep F3-F4, and alternate level L2.

Commands: L2, XL2

Anritsu MG369 C Series User Manual

Questions and Answers: