Command Directory 3-4 Commands
MG369xC GPIB PM PN: 10370-10374 Rev. F 3-5
AF1
Description: Selects F1-F2 alternate frequency sweep.
Selects an alternate F1-F2 frequency sweep. If the MG369xC is sweeping when AF1 is
received, the instrument’s output will alternate between the commanded sweep and the
sweep being executed. An alternate sweep command will only be recognized when the
MG369xC has been programmed to sweep. It will be ignored at all other times.
Functional
Category: SWEEP
Example: SSP; SF1; AF1
Sets step sweep F1-F2 and alternate step sweep F1-F2.
Related
Commands: F1, F2
Front Panel Key: Frequency | Step Sweep | More > | Alternate Sweep > | Alternate Range | F1 - F2
AF3
Description: Selects F3-F4 alternate frequency sweep.
Selects an alternate F3-F4 frequency sweep. If the MG369xC is sweeping when AF3 is
received, the instrument’s output will alternate between the commanded sweep and the
sweep being executed. An alternate sweep command will only be recognized when the
MG369xC has been programmed to sweep. It will be ignored at all other times.
Functional
Category: SWEEP
Example: SSP; SF1; AF3
Sets step sweep F1-F2 and alternate step sweep F3-F4.
Related
Commands: F3, F4
Front Panel Key: Frequency | Step Sweep | More > | Alternate Sweep > | Alternate Range | F3 - F4
AFU
Description: Selects full range alternate frequency sweep.
Selects an alternate full range frequency sweep. If the MG369xC is sweeping when AFU
is received, the instrument’s output will alternate between the commanded sweep and
the sweep being executed. An alternate sweep command will only be recognized when the
MG369xC has been programmed to sweep. It will be ignored at all other times.
Functional
Category: SWEEP
Example: SSP; SF1; AFU
Sets step sweep F1-F2 and full range alternate step sweep.
Front Panel Key: Frequency | Step Sweep | More > | Alternate Sweep > | Alternate Range | Full
To Next Page
Loading...
Need help?
General
