Command Directory 3-4 Commands
MG369xC GPIB PM PN: 10370-10374 Rev. F 3-99
RSN(m)
Description: Recalls the instrument setup stored in internal setup memory location M.
Recalls a stored instrument setup from the internal setup memory location specified
(1 to 9).
Functional
Category: STORED SETUP
Value: M: memory locations 1 to 9
Related
Commands: SSN(m)
Front Panel Key: System | Setups | Recall (enter setup number to be recalled)
RSS
Description: Resets a sweep if in progress.
Resets the sweep to its start frequency (or power level), whenever the command is
received while a single sweep is in progress.
Functional
Category: SWEEP
Related
Commands: TRG, TRS
Front Panel Key: Frequency | Step Sweep | More > | Trigger > | Single | Trigger to start single sweep or
reset sweep
Frequency | List | Sweep > | Trigger > | Single | Trigger to start single sweep or reset
sweep
Level | Level Sweep | Trigger > | Single | Trigger to start single sweep or reset sweep
RST
Description: Resets the MG369xC to its default settings.
Sending this command clears the current instrument setup. If this setup is needed for
future testing, save it as a stored setup using the command SSN(M1-9) or SAF before
sending RST.
Functional
Category: MISCELLANEOUS
Front Panel Key: System | Reset
RT0
Description: Selects RF to be off during retrace.
Functional
Category: CONFIGURATION
Front Panel Key: System | Config | RF | Retrace RF to Off
RT1
Description: Selects RF to be on during retrace.
Functional
Category: CONFIGURATION
Front Panel Key: System | Config | RF | Retrace RF to On
To Next Page
Loading...
Need help?
General
