Anritsu Site Master S113B - Page 6

Saving a Display to Memory ............................4-4
Recalling a Display From Memory ........................4-4
SWR (Return Loss) and Cable Loss Measurement ............4-6
Required Equipment ................................4-6
Device-Under-Test Specification..........................4-6
Procedure ......................................4-6
Selecting the Measurement Mode .........................4-6
Selecting the Frequency Range ..........................4-6
Performing a Calibration .............................4-7
SWR or Return Loss Measurement ........................4-8
Set the Amplitude Scale and Limit Line .....................4-8
Setting the Markers.................................4-9
Cable Loss Measurement ..........................4-10
Setting the Amplitude Scale ...........................4-10
Setting the Markers ................................4-11
DTF Measurement .............................4-12
Required Equipment ...............................4-12
Device-Under-Test Specification .........................4-12
Procedure .....................................4-12
Selecting the Measurement Mode ........................4-12
Performing a Calibration .............................4-13
DTF Measurement (Determining the Length of the Cable) ..........4-14
Setting the Amplitude Scale ...........................4-14
Setting the Marker ................................4-14
DTF Measurement (Determining the quality of the cable.) ..........4-16
Setting the Amplitude Scale ...........................4-16
Setting the Markers ................................4-16
Making Power Measurements .......................4-18
Entering Power Monitor Mode..........................4-18
Zeroing the Power Monitor............................4-18
Measuring High Input Power Levels.......................4-18
Displaying Power in dBm and Watts ......................4-18
Displaying Relative Power ............................4-18
Making a Measurement with the Spectrum Analyzer ..........4-19
Example – Measuring a 900 MHz signal..................4-19
Set the Site Master to Spectrum Analyzer mode ................4-19
Set the center frequency .............................4-19
Set the frequency span ..............................4-20
Setting the marker.................................4-20
Set the Reference Level ..............................4-21
Chapter 5 - Software Tools Program 5-1
Description ..................................5-1
Requirements .................................5-1
Communication Port Setting.........................5-1
Changing COM Port Settings–Windows 95/98/NT ...............5-1
Software Installation .............................5-3
Plot Capture..................................5-3
Capture multiple traces to a database.......................5-4
Capture single or multiple traces to PC screen..................5-4
Program Operation..............................5-5
ii