To Next Page

To Previous Page

IQ-636X-2/E Installation Manual — P/N 52853:K3 9/28/15 29

Mounting Option Boards Installation

3.6.4 Transmitter Module TM-4

TM-4 is power-limited. Connections are on TB10 nonresettable output and TB11 EIA-485 ACS

Mode. Refer to the Transmitter Module TM-4 installation document for installation details.

3.6.5 Loop Expander Module

Installing a Loop Expander Module

adds a second SLC loop to the control

panel. Refer to Figure 3.12 for stacker-

connector illustrations.

1. Plug short end of the stacker-

connector into J4 on the IQ636X-

CPU2.

2. Align the LEM with the four

1 inch standoffs and the stacker-

connector as shown in

Figure 3.12; firmly seat the

stacker-connector.

3. Attach LEM to standoffs using

screws or another set of standoffs.

4. After LEM is mounted on the

control panel, connect the SLC

loops to TB1 on the LEM and

TB13 on the IQ636X-CPU2. This

system supports either FlashScan

or CLIP mode devices. Refer to

the SLC loop manual for wiring

requirements and specific details.

LEM-SLC.wmf

Figure 3.11 SLC Connections for LEM-320

Attach stacker-connector to CPU as

shown in Figure 3.12.

CAUTION:

For the SLC to function correctly, the stacker-connector must be installed as shown in Figure 3.12.

Do not install other option modules on top of the LEM-320.

Ansul AUTOPULSE IQ-636X-2/E User Manual

Questions and Answers: