Ansul AUTOPULSE IQ-636X-2/E User Manual

IQ-636X-2/E Installation Manual — P/N 52853:K3 9/28/15 47
Central Station Fire Alarm System Canadian Requirements Applications
4.4 Central Station Fire Alarm System Canadian
Requirements
For Canadian applications requiring a second dial-out option, refer to the following illustration for
UDACT/UDACT-2 and TM-4 setup:
Figure 4.3 Central Station Canadian Requirements for Second Dial-Out Connection
4.5 NFPA 72 Proprietary Fire Alarm Systems
When connected and configured as a protected premises unit with UDACT or UDACT-2, the IQ-
636X-2/E will automatically transmit General Alarm, General Trouble, and General Supervisory
signals to a listed compatible Protected Premises Receiving Unit. See the UDACT Manual or
UDACT-2 Manual for compatible receiving units. A simplified drawing of connections between the
receiving unit and the IQ-636X-2/E protected premises unit is shown in Figure 4.4.
Connect the receiving unit to the protected premises unit as shown in Section 4.3 “NFPA 72 Central
or Remote Station Fire Alarm System (Protected Premises Unit)”.
For information on installing and programming the Receiving unit, refer to the documentation for
that control panel.
0
NO
ON
NC
C
18/24
115
230
1
1
S5W
LED3
LED4
LED1LED2
S1W
ELR
TXACS
RXACS
POWER
TROUBLE
SW4
REMOTE
STATION
ALARM
ACS
TB2 TB1
ACS RE F
REMOTE
STATION
SUPERVISORY
MUNICIPAL
BOX
REMOTE
STATION
TROUB LE
T3B
S2W
S3W
SW6
NON-ISOLATED
DISABLE
ISOLATED
ENABLE
+24VDC REF
+
-
LINE SEIZE
LED 3
LED 20
LED 8
LED 2
LED 1
LED 9
LED 14
LED 13
+ 24V
COMMON
INPUT 1
INPUT 2
INPUT 3INPUT 4INPUT 5
TRANS
CLEAR
SW1
SW2
SW3
SW4
RESET
TEST
REPORT
REAL TIME
EIA-485 COMM LOSS
POWER
LED 5
LED 6
LED 7
LED 17
LED 18
LED 19
LED 4
LED 15
LED 16
LINE FAIL
NO TONE
KISS OFF
COMM FAIL
PRI
SEC
OPTION
SELECT
SWITCH
1 2 3 4
OFF
ON
ON
LED21
TONE DETECT
EIA-485
Relay
Drive
24V
24V
+
_
+
+
+
+
IQ-636X-2/E
_
_
__
TM-4
UDACT-2
MR-101/C
FMM-1
SLC
+
EIA-485
24V
EIA-485
+
_
{
{
{
{
24V
EIA-485
_
NOTES:
• Drawing is not to scale.
• The UDACT/UDACT-2 should
be set for “Receive Only” for
this configuration. For
additional UDACT/UDACT-2
setup information, refer to the
UDACT Installation Manual. or
UDACT-2 Instruction Manual.
• For additional setup information
on the TM-4, refer to the TM-4
Instruction Manual.

Ansul AUTOPULSE IQ-636X-2/E Specifications

General

Brand	Ansul
Model	AUTOPULSE IQ-636X-2/E
Category	Control Systems
Language	English