Operating Modes Appendix C: Remote Terminal Access
IQ-636X Operations Manual P/N 52181:A 04/28/2005 69
Local Monitor Mode (LocM)
Functions, passwords, and special requirements of Local Monitor Mode (LocM) are:
Functions available with the Local Monitor Mode:
Table 20 Local Monitor Mode Functions
Functions: Read Status, Alter Status, and Control Functions (Table 20).
Passwords: User-defined password for Alter Status and Control functions.
Requirements: Password security feature for Control Functions eliminates the need for
mounting the CRT-2 in an enclosure.
Function Lets you...
Read Status • Display the status of an individual point (Detector, Module, Panel
Circuit, or Zone).
• Display a list of all the points in Alarm or trouble.
• Display a list of all programmed points in the system.
• Step through the History buffer event by event.
• Display the entire History buffer.
Alter Status • Disable/Enable an individual point.
• Change the sensitivity of a detector.
• Clear the verification counter of all detectors.
• Clear the entire History buffer.
• Set the AWACS alert and action levels.
Control
Functions
• Acknowledge
• Signal Silence
• System Reset
•Drill
To Next Page
Loading...
Need help?
General
