EasyManua.ls Logo

Ansul INERGEN 150-BAR - CV-98 Electric Actuator

Ansul INERGEN 150-BAR
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
System Components
UL EX-4510 2-1-12 Page 1-2.1
REV. 3
Description
Electrical actuation of a CV-98 INERGEN® valve is accom-
plished by a CV-98 electric actuator interfaced through an
AUTOPULSE Control System. This actuator can be used in
hazardous environments where the ambient temperature
range is between 32 °F to 130 °F (0 °C to 54 °C). The elec-
tric actuator meets the requirements of N.E.C. Class I, Div.
1, Groups B, C, D and Class II, Div. 1, Groups E, F, G. A
maximum of two CV-98 electric actuators can be used on a
single AUTOPULSE release circuit. When using either one
or two CV-98 electric actuators, a current limiter module,
Part No. 427354, must always be used.
The Actuator Shipping Assembly contains a current limiter
module along with an installation instruction sheet.
The actuator specifications are:
Nominal Voltage
24 VDC @ .75 amps
In auxiliary or override applications, a manual cable pull
actuator can be installed on top of the CV-98 electric
actuator by removing the safety cap.
A manual lever actuator, Part No. 423309, is available for
use with the CV-98 electric actuator.
The actuator contains a standard 1/2 in. threaded female
straight connector for electrical conduit hookup.
The CV-98 electric actuator uses a replaceable
METRON® PROTRACTOR which is a device designed to
produce a high force mechanical output. The actuator is
electrically actuated and will operate within milliseconds.
The METRON PROTRACTOR must be replaced after
discharge of the INERGEN system.
CV-98 Electric Actuator
Shipping Assembly
Part No. Description
423684 CV-98 Electric Actuator
423958 Replaceable METRON
PROTRACTOR
427354 Current Limiter Module
001395
5 5/16 IN.
(13.5 cm)
1 1/8 – 18
1 1/8 – 18
1/2 IN.
CONDUIT
THREADS
CAUTION
LABEL
1 7/8 IN. HEX
(4.8 cm)
Component Material Thread Size/Type Approvals
CV-98 Electric Actuator Body: 1/2 in. Straight Female UL (E62842);
Brass on Conduit Connection Listed for use with
METRON PROTRACTOR FM Approved systems
Plunger:
Stainless Steel
ANSUL
®
Copyright © 2012 Tyco Fire Products LP.
All rights reserved.
Form No. F-9878-03
One Stanton Street +1-715-735-7411
Marinette, WI 54143-2542 www.ansul.com

Related product manuals