11
Digital DMR and Analog UHF/VHF Two Way Radio
Work Alone Turn on/off the work alone function.
Nuisance Delete
During scanning, press the key to skip the unwanted channel
Digi Monitor In DMR mode, press the key to turn on/off digital monitor
Sub CH Hide Turn on/ off the sub channel
Prior Zone Switch to Priority Zone
VFO Scan
Press the key to start or stop the VFO scan.
The VFO scan start and end frequency should be set in CPS -Optional
Setting - VFO Scan.
Enhance Sound
In digital channel, switch the microphone tone to normal or enhanced mode.
LastCall Reply
In digital channel, press the key to access the last call and press PTT
to call back.
Switch ChType
Switch the channel type(Analog, Digital, Ana+Dgi, Dgi+Ana)
Ranging
When the radio receives a call and the suspension time is on, press
the key programmed as" Ranging" to obtain the caller's position and
distance. (Both party need GPS positioned, or will receive only GPS
information)
Roaming
In standby, press the key programmed as "Roaming" to search
lock on the repeater with strongest signal. (Note: After lock on
repeater, the radio will return to last frequency only after
or frequency is changed. The repeater frequency list must pre-
programmed in CPS.)
Channel
Ranging
In standby, if the call contact type for a channel is "Private call" , press
the key programmed as " Channel Ranging" to turn on this function. The
radio will automatically start ranging function when turn to this channel.
Max VOL Set
In standby, press the key programmed as "Max Volume", will enable
users to set the maximum RX volume.
Slot Set
Choose Slot for current channel, this function is only valid in repeater mode.
Aprs Type Choose Aprs Type for current channel.
Zone Select
In standby, press the programmed "Zone Select" key, it will allow you
input the zone number and then press confirm key will switch to the zone.
Roaming Set Sets Roaming Function
APRS Set Sets APRS Function
Mute Timing
Press the key to mute the radio in set time. The mute timing should be
set in CPS -Optional Setting - Other -Mute Timing.
CTC/DCS Set
Set the CTCSS/DCS for analog channel
TBST Send Send the TBST Tone
Bluetooth Enable / disable the bluetooth function
GPS Enable / disable the GPS function
Ch. Name
Switch between channel name display and frequency display for the
current channel
To Next Page
Loading...
Need help?
General
