15
Digital DMR and Analog UHF/VHF Two Way Radio
d.
When the call is ended, it will display “Call end”, and you can press [PTT]
to respond the call.
5.10
Making a Call
Method 1: from the Channel switch.
Turn the channel switch to choose a programmed channel.
Method 2: from the Talk Group.
(1)
Turn the channel switch to choose a programmed channel;
(2)
Press (exit) key to enter the TG List, press the / key to
choose a TG.
Method 3: from the keypad.
(1)
Turn the channel switch to choose a programmed channel.
(2)
Press (Menu) key to Talk Group, press select to enter TG.
(3)
Press / key to Manual Dial, press Select.
(4)
Input the ID number by keypad, press key to switch group ID or
Private DMR ID.
Hold the radio vertical 2.5-5cm from your mouth, press the [PTT] key to
start the call, the red LED lights up, the receiver ID/name/city/state/country/
call type and call out icon will be display on the LCD.
Release [PTT] key to receive the reply.
5.11
Monitor
In standby, press the [PF2] key to enter Monitor. When receiving matched
carrier but the signaling / ID is unmatched or the signal is too weak, this
function allows monitor the weak signal and signal with unmatched ID.
Press the [PF2] key again to shut off speaker and return to standby.
» When in analog mode, if no signal, it will emit noise when press the
Monitor Key. ** The Rx icon is seen when monitor is activated.
5.12
Emergency Alarm
Press Emergency Alarm key [PF3] to turn alarm function, then press this
key again to return.
5.13
Man Down Alarm
a.
Press (Menu) to enter main Menu, press / key to Settings.
b.
Select Radio Set, press, press / key to Man Down.
c.
Select Man Down On to turn on the function.
To Next Page
Loading...
Need help?
General
