-47-
Note: When you use dynamic IP addresses, you do not have select “Use static IP
addresses” to configure the network settings.
3. After “IP settings,” go back to the Wi-Fi settings interface and tap the wireless
network you want to connect to. After the network connection is successfully
established, you can login to the network to surf the Internet.
Checking status of wireless network
You can check the status of the currently
connected Wi-Fi through the following
methods:
·Status bar
After the product is connected to the
wireless network, the Wi-Fi indicator on the
top of it lights up and the status bar shows
the Wi-Fi icon “
” and signal strength (the number of the bars lighting up).
·Wi-Fi network
In the network connection interface, tap “Wi-Fi settings” and tap the currently
connected wireless network to show the information, such as name, status, speed,
signal strength, and security.
Tip: If you want to remove the network settings, tap “Forget” in this window; if you
want to connect to this network, the settings above should be configured again.
Connecting to other Wi-Fi networks
1. In the network connection interface, tap “Wi-Fi settings.” The detected Wi-Fi
networks will be shown in the Wi-Fi network zone.
Tip: If you want to manually scan for available networks, press the M button and tap
“Scan.”
2. Tap another Wi-Fi network to connect to it.
Tip 1: If the network you want to connect to is not listed in the detected network list,
Tap “Add Wi-Fi network,” enter the corresponding network settings, and tap “Save.”
Tip 2: Not all wireless networks are connected to the Internet. Some wireless
To Next Page
Loading...
Need help?
General
