Set the E2 and the ash lights to the
same radio channel.
Select the same group settings for all
ash heads that shall be controlled
simultaneously.
Set the Group of E2 to the same as
the group setting for the ash heads
to be controlled, or select all groups
on E2.
Press the Test Button [8] on the E2
to verify that the ash heads re as
expected.
Turn all ash heads in the selected
group(s) on/off by pressing the Head
Control Button [5] on the E2.
Turn the modeling light in the selected
group(s) on/off by pressing the Model
Control Button [12] on the E2.
Increase/decrease the energy level of
the selected group(s) by pressing the
Energy Adjustment Button [6] on the
E2.
• 25 •
To Next Page
Loading...