Set E2 (b) to Receive Mode (Mode
Indicator [7] <RECEIVE> blinks
green), use a ash sync cable to
connect the Out Port [18] on the E2
to the ash light’s sync input socket
(or PC terminal depends on the ash
light) . *
Set E2 (a) and E2 (b) to the same
radio channel.
Press the Test Button [8] on E2 (a)
to verify that the ash light res as
expected.
When working with the ash light
without built-in AODELAN radio
system, only sync trigger functionality
is supported.
* For proper connection with the camera or flash
light, consult the user manual of the actual camera
or ash light at the same time.
• 27 •
To Next Page
Loading...