4. Using E2 as a wired shutter release.
(Figure 8)
(Figure 8)
Under the same situation as in Section
3, press and hold down the Test Button
[8] on the E2(b) can also release the
camera directly, to use one single E2
as a wired shutter release
。
***
*** For a single shot, set the camera to single
mode. If the camera is set to continuous mode, the
camera will continue shooting as long as the Test
Button [8] is held down; because of a lag effect, the
camera might take a few more shots after the Test
Button [8] has been released. Continuous mode is
recommended for shooting with 2 fps or faster.
• 31 •
To Next Page
Loading...