Set the E2 (b) to Relay State Receive
Mode (Mode Indicator [7] <RECEIVE>
blinks red) and select a radio channel.
Use a ash sync cable to connect
the Out Port [18] on the E2 (c) to the
ash light’s sync input socket (or PC
terminal depends on the ash light). *
Set the E2 (c) to Standard State
Receive Mode (Mode Indicator [7]
<RECEIVE> blinks green) and select
the same radio channel as on E2 (b).
* For proper connection with the camera or flash
light, consult the user manual of the actual camera
or ash light at the same time.
• 38 •
To Next Page
Loading...