Hand hold E2 (a) and set it to Relay
State Transmit Mode (Mode Indicator
[7] <TRANSMIT> blinks red) and
select the same radio channel as on
E2 (b).
Press and hold down the Test Button
[8] on the handheld E2 (a), E2 (b) will
release the camera’s shutter to take
a picture and synchronously trigger
E2(c) to re the ash light.
Note:
E2(c) must be set to the
Standard State Receive Mode. If E2(c)
is also set to the Relay State Receive
Mode, E2(a) will directly trigger E2(b)
and E2(c) simultaneously, the flash
light will not flash in synchronization
with the camera shooting, then the
Relay function will not be achieved.
• 39 •
To Next Page
Loading...