AODELAN E3+ - Page 11

9
Turn On/Off the E3
+
Transmitter
1. Turn On: Press and hold the power button until MENU interface is
displayed on screen.
2. Turn off: Press and hold the power button until the LCD screen goes
blank.
Note: When
is displayed, please replace the batteries with new ones.
USB Port
The rmware of E3
+
transmitter can be upgraded via the USB port, so as to
adjust its parameter and extend its compatibility with cameras to come in the
future.
1. Connect the USB cable to the computer and the other end of the USB
cable to E3
+
transmitter’s USB port. A mobile device icon will be displayed on
the computer when successfully connected.
2 Double click to start the upgrade software. The upgrade software can be
used to check version info, and upgrade the Base software, RF software and
Icon.
Click "Version" icon, the current version information of the connected E3
+
transmitter will be displayed in the software window.
Click "Base software" icon, locate and double click on the FDS le from the
pop-out window. Then it starts loading the new rmware.
Click "RF software" icon, locate and double click on the RFC le from the
pop-out window. Then it starts loading the new rmware.