10
Click "Icon" icon, locate and double click on the FIF le from the pop-out
window. Then it starts loading the new rmware.
3. The status of the upgrade will be displayed in the process bar. When
completed, an “Updata OK”will be displayed at the bottom of the upgrade
software window, and a “Download OK” will be displayed on the transmitter’s
LCD screen. Upon completion, disconnect the USB cable and restart the E3
+
transmitter.
Note:
Please ensure stable power supply when attempting to upgrade the E3
+
transmitter. Loss of computer power during the upgrade process could fail
the upgrading.
Check Version Info on E3
+
Transmitter
You can check the present version information on E3
+
transmitter: While
pressing the power button to turn on the transmitter, press the ash < >
button simultaneously until the version info is displayed on the LCD screen.
<
>
Charge Lamp/Test Flash Button
1. The charge lamp lights when the wireless shooting (slave) is ready.
2. During wireless shooting, master unit’s charge lamp will be lit when all
slave units are fully charged.
3. During wireless shooting, you can press the transmitter’s charge lamp (test
ash button) to re a test ash.
To Next Page
Loading...
