11
Remote Release from Slave Unit
When performing wireless shooting, E3
+
transmitter supports remote release
(remote control shooting) from a ash set or E3
+
receiver as a slave unit. For
operations, see the ash or E3
+
receiver’s instruction manual.
Note:
When using the remote release function, the slave unit camera might need
a shutter release cable(available separately) depending on the camera
models.
1) EOS digital cameras since 2012 (excluding EOS 1200D) do not need to
use shutter release cable.
2) EOS cameras before 2012, which are compatible with E-TTL II/E-TTL
autoash and come with N3 type remote terminal EOS, shutter release
cable will be needed for remote release.
Test Flash from a Slave Unit
You can re a test ash from a ash set as a slave unit. For operations, see
the ash’s instruction manual.
Note: When two or more units are set to master, the unit with the <
>
lamp lit in green is the one that res.
Modeling Flash
1. Modeling Flash from a Master Unit
When the camera’s dept-of-view preview button is pressed, the ash will re
To Next Page
Loading...
