12
continuously for 1 sec. This is called the modeling ash. It enables you to
see the shadow effects of the ash on the subject and the lighting balance.
Besides, you can also re the modeling ash by pressing the charge lamp/
test ash button on E3
+
transmitter (the operation required to be enabled in
advance by setting C.Fn 02).
2. Modeling Flash from a Slave Unit
With EOS digital cameras released since 2012, you can re the modeling
ash from a ash set as a slave unit. For the operations, see the ash’s
instruction manual.
AF Assist Light
In low light/contrast situation, the E3
+
transmitter’s built-in Auto Focus Assist
Light will illuminate to assist with AF. The AF Assist Light on the front of the
transmitter will project a focusing target on the subject. As laser light, the AF
assist light is featured little decay, great directionality and assist performance.
You can choose to enable or disable the AF assist light by setting P. Fn 08.
Note: The laser AF assist light is safe with optical power less than 5mW.
However, please still avoid pointing the light at human eyes.
Memory Function
E3
+
transmitter supports memory function. You can save the wireless settings
and recall the setting later.
1. Press function button 4 until
is displayed.
2. Save or load the settings
To Next Page
Loading...
