87
12.2.
USE
12.2.1 DESCRIPTION OF THE MACHINE OPERATION
START UP OF THE BAKING CHAMBER WITHOUT STEAM GENERATOR
You are referred to the end of the manual for the specific instructions regarding the control panels.
NOTE: The electronic instruments allow a more precise and evolved regulation of the oven.
However it is a very delicate instrument by definition compared with the traditional
electromechanical kind.
For better conservation of the same you are advised to press the knobs on the electronic panel with
lightly your fingers and do not bang or press it too hard.
Chamber right side – components side
START UP OF THE BAKING CHAMBER WITH STEAM GENERATOR (for versions provided with steam
generator)
Before issuing the steam it is necessary to activate the steam generator and wait at least 40 minutes to allow
the generator to finish the pre-heating phase. If this is not done water will leave the steam generator
discharge point immediately and steam will not be produced. The thermostat inside the steam generator is
preset in the factory 180°C approximately to guarantee normal use.
STEAM EVACUATION
The discharge of steam forming inside the baking chamber is operated by means of knob situated on the
front right-hand upright of the oven.
With the handle turned to the left the discharge is open and towards the right it is closed.
Steam chamber valve
To Next Page
Loading...