APC Smart-UPS 2200 User Manual

4 Smart-UPS 2200/3000 VA 230 VAC Tower User Manual
Introduction
Introduction
About this UPS
The APC
™
by Schneider Electric Smart-UPS
™
is a high performance uninterruptible power supply (UPS). The
UPS provides protection for electronic equipment from utility power blackouts, brownouts, sags, and surges,
small utility power fluctuations and large disturbances. The UPS also provides battery backup power for
connected equipment until utility power returns to safe levels or the batteries are fully discharged.
This user manual is available on the APC by Schneider Electric Web site, www.apc.com.
Installation
Unpack
Read the Safety Guide before installing the UPS.
Inspect the UPS upon receipt. Notify the carrier and dealer if there is damage.
The packaging is recyclable; save it for reuse or dispose of it properly.
Check the package contents:
Position the UPS in the Specified Environment
The UPS is heavy. Select a location sturdy enough to handle the weight.
Do not operate the UPS where there is excessive dust or the temperature or humidity are outside the specified
limits:
•UPS
• EPO connector
• UPS literature kit
containing:
– product documentation
– safety information
– warranty information
UPS literature kit additional contents:
• PowerChute
™
CD
•Serial and USB
communication cables
• input power cord
• utility connector plug
• IEC jumper cables
0°C
40°C
0% - 95%
1” (2.5 cm)
040
C
-

APC Smart-UPS 2200 Specifications

General

Nominal Output Voltage	230V
Nominal Input Voltage	230V
Rack Height	2U
Input Voltage Range	160 - 286 V
Waveform Type	Sine wave
Interface Port	USB
Typical Recharge Time	3 hours
Form Factor	Rackmount/Tower
Frequency	50/60 Hz
Battery Type	Sealed Lead Acid (SLA)