BASIC REQUIREMENTS AND SAFE USE
- The manufacturer will not be liable for damage resulting from incorrect installation,
failure to maintain the device in a suitably functional condition, or use of the device
other than for its intended purpose.
- Installation should be carried out by qualified personnel having the necessary authorisation
to install electrical and pressure measuring devices. The installer is responsible for
performing the installation in accordance with these instructions and with the
electromagnetic compatibility and safety regulations and standards applicable to the type of
installation.
- The device should be configured appropriately for the purpose for which it is to be used.
Incorrect configuration may cause erroneous functioning, leading to damage to the device
or an accident.
- In systems with pressure transmitters there exists, in case of leakage, a risk to personnel
on the side where the medium is under pressure. All safety and protection requirements
must be observed during installation, operation and inspections.
- If a device is not functioning correctly, disconnect it and send it for repair to the
manufacturer or to a firm authorised by the manufacturer.
In order to minimise the risk of malfunction and associated risks to personnel, the device is
not to be installed or used in particularly hostile conditions, where the following risks occur:
- possibility of mechanical impacts, excessive shocks and vibration;
- excessive temperature fluctuation;
- condensation of water vapour, dust, icing.
Installation of intrinsically safe versions should be performed with particular care, in accordance
with the regulations and standards applicable to that type of installation.
Changes in the production of transmitters may precede a paper updating for the user.
The current user manuals are available at http. www.aplisens.pl
To Next Page
Loading...
Need help?
General
