Apogee ensemble Quick Start Guide

Ensemble Quick Start Guide | 19
Select the Input Source
NOTE: G1 and G2 are always instrument
inputs and therefore have no option to
change the input source.
From the Front Panel From Maestro
1. Press and hold the
desired Input Select
button for at least
1 second.
1. Open Maestro and select the
Input tab at the top
(or use the keyboard
combination [command 1]).
2.TotherightofAnalogLevel,clicktheboxinthedesired
input channel to select your input source.
2. Turn the Input knob to
highlight “Input”.
3. Press the Input knob to
change the input source.
4. Press and hold the Input
Select button for at least
1 second to return to the
Input level meter screen.
• Set to “Mic” if connecting a microphone.
• Set to “Inst” if connecting instruments.
• Set to “+4dBu” or “-10dBV” if connecting
a line level signal such as an external
preamp or mixer.
• Set to “Mic” if connecting a microphone.
• Set to “Inst” if connecting instruments.
• Set to “+4dBu” or “-10dBV” if connecting
a line level signal such as an external
preamp or mixer.
IN1
1
Input Mic
Soft Limit Off
Group Off
Insert Off
Off
48v On
Off
-30
INT
44.1

Apogee ensemble Specifications

General

Type	Audio Interface
Simultaneous Channels	36
Phantom Power	Yes
Word Clock	Yes
Bit Depth	24-bit
Digital Inputs	ADAT, S/PDIF
Digital Outputs	ADAT, S/PDIF
Connectivity	FireWire
Inputs	8 analog
Outputs	8 analog