4.13.6 Adding or Editing Meters
Adding of new meter (using key F3) and editing of selected meter parameters (using key F2) are
performed on screens with same content only the names of the screens are different.
In Editing mode all actual meter parameters are shown in four screens and user can edit any of them
and save the changes using F4 key.
In Adding mode all actual meter parameters are shown in four screens and after changing required
parameters new meter is saved into database of meters. Newly added meter has associated no results
of tests (load points).
Control keys:
F1, ESC .......... Termination without saving changes or adding new meter
F4 ................... Saving of changes or adding new meter
F5 ................... Switching between screens
To Next Page
Loading...
Need help?
General
