Need help?Do you have a question about the APRILIA MX 50 and is the answer not in the manual?
General| Transmission | 6-speed |
|---|---|
| Engine Type | Single cylinder, two-stroke |
| Cooling System | Liquid-cooled |
| Front Suspension | Upside-down fork |
| Rear Suspension | Monoshock |
| Front Brake | Disc |
| Rear Brake | Disc |
Set speed units (KM/H or MPH) and wheel diameter for accurate readings.
Configure the 12h or 24h time format and set the current time.
Configure service intervals for lubrication checks and set them to zero if unused.
Configure service intervals for maintenance checks and understand ODO wording.
Step-by-step guide to access and replace the digital instrument's battery.
Describes the three positions of the ignition switch: start, stop, and steering lock.
Check tyres, fuel, oil levels, and coolant before first use.
Covers checks for brakes, accelerator, oil, tyres, clutch, and steering.
Steps for starting the engine, including fuel, ignition, neutral, and kick-starter use.
Specific steps for starting a cold engine using the choke and warming it up.
Instructions for starting from a stop, engaging gear, and releasing the clutch.
Steps to safely stop the engine, including neutral gear and fuel cock.
Chart outlining scheduled maintenance tasks and their intervals.
Procedure to check the gear oil level using the checking screw.
Verify the idle stroke of the clutch lever and adjust if necessary.
Top up the mixer oil tank every 500 km; note the reserve warning light indication.
Modify the rear brake pedal height and ensure correct clearance.
Inspect brake pads for wear every 2,000 km or after off-road use.
Modify spring pre-loading based on rider weight for optimal ride position.
To Next Page