64
LOW / HIGH BEAM BULB (HALOG-ENOUS)
To extract the bulb electric connector, do
not pull its electric wires.
◆ Grasp the bulb electric connector, pull it and di-
sconnect it from the bulb (8).
◆ Remove housing (9) from reflector and from bulb
terminals
◆ Turn bulb holder (8) anticlockwise to remove it
from reflector
◆ Remove bulb (2) from its location
For the installation:
Insert the bulb in the bulb socket, making
the relevant positioning seats coincide.
◆ Position bulb holder (8) into reflector and turn it
clockwise.
◆ Correctly install housing (9) inside bulb terminals
and reflector.
◆ Connect bulb connector.
To Next Page