APsystems ECU-3 - Connecting Directly to the ECU; Using A Windows-Based Pc

APsytems ECU-3 V8.0 Installation/User Manual 18 18
LOCAL NETWORK INTERFACE
CONNECTING DIRECTLY TO THE ECU
Using a Windows-based PC
1. Connect the computer to the ECU using a CAT5 network cable.
2. Power up the ECU by connecting the power cable.
3. Open the “Network and Sharing Center” in the Control Panel on
the PC.
4. Select “Local Area Connection” for “Unidentied Network”.
5. Select “Properties” when “Local Area Connection Status” (LAC)
window is displayed.
6. Highlight “Internet Protocol Version 4 (TCP/IPv4)” when the
“Local Area Connection Properties” window is displayed.
7. Select “Use the Following IP Address” radial button and the
enter IP Address and Subnet Mask as listed below. Do not enter
anything in the DNS Server address section.
IP Address: 60.190.131.190
Subnet Mask: 255.0.0.0
8. Select “OK” on the IPv4 Properties window.
9. Close the LAC Properties window.
10. Close the LAC Status window.
11. Close the Network and Sharing Center.
12. Using a standard web browser on your computer, enter the IP
Address that is displayed on your ECU in to the URL search eld.
Figure 20