APsytems ECU-3 V8.0 Installation/User Manual 30 30
LOCAL NETWORK INTERFACE
MANAGING THE WLAN/WIFI CONNECTION
The ECU operates in two communication modes: WLAN and as a wi hub.
When operating in WLAN mode, the ECU connects to the local network
router via its wi capabilities (eliminating the need for a PLC bridge
or wi extender between the ECU and network router), allowing you to
monitor and manage the ECU through the local network.
When functioning as a wi hub, the ECU can directly communicate
wirelessly with mobile devices, and/or a PC.
NOTE: The ECU’s wireless functionality is for ongoing monitoring and
ECU management, not initial installation. Initial ECU installation
requires that you use a wi extender, PLC bridge, or direct CAT5
connection to the network router.
NOTE: The ECU operates as a wi hub by default.
To Change the ECU to WLAN Mode
1. Select “Administration” tab at the top of the page.
2. Select “WLAN” tab.
WLAN Tab
Figure 34
To Next Page
Loading...