APsystems ECU-3 - If Manually Entering the Uids into the ECU; Adding Additional Inverter Uids; Deleting An Existing Inverter Uid

APsytems ECU-3 V8.0 Installation/User Manual 23 23
LOCAL NETWORK INTERFACE
If Manually Entering the UIDs into the ECU
1. Enter each 12-digit inverter UID, followed by pressing the “Enter/
Return” key (providing a line break between each entry).
2. Once all the UID have been entered, press “Update”.
“ID updated successfully” message is displayed.
If Using a Scanning Gun to Enter the UIDs into the ECU
1. Copy the scanned UIDs into the ID Management box.
2. Once all the UID have been copied, press “Update”.
“ID updated successfully” message is displayed.
Adding Additional Inverter UIDs
1. Select “Administration” tab at the top of the page.
The UID Management page with the existing inverter UIDs is displayed.
2. Scroll down to the end of the existing list.
3. Enter the new UID.
4. Press “Update”.
Deleting an Existing Inverter UID
1. Select “Administration” at the top of the page.
The UID Management page with the existing inverter UIDs is displayed.
3. Delete the “obsolete” UIDs from the list.
4. Press “Update”.
Figure 25