APsystems ECU-3 - Managing the Network Connection; Assigning A Static Ip Address To The Ecu

APsytems ECU-3 V8.0 Installation/User Manual 28 28
LOCAL NETWORK INTERFACE
MANAGING THE NETWORK CONNECTION
The default network connection setting for the ECU is “DHCP” which
allows the ECU to automatically establish a connection assignment from
the router. The ECU can be assigned a static IP Address if the network
design requires it.
Assigning a Static IP Address to the ECU
1. Select “Administration” tab at the top of the page.
2. Select “Network Connectivity” tab.
The Network Connectivity page is displayed.
3. Select the “Use the following IP address” button.
Figure 31
Network Connectivity Tab
Use the following IP address button
Figure 32