APsytems ECU-3 V8.0 Installation/User Manual 22 22
LOCAL NETWORK INTERFACE
MANAGING INVERTER UIDS
The inverter UIDs must be programmed into the ECU for the ECU to
recognize the inverters. The ECU will NOT auto-sense the inverters.
Initial Programming of the Inverter UIDs into the ECU
1. Select “Administration” at the top of the page.
The UID Management page is displayed.
NOTE: The “Enter Inverter ID” window eld will be blank if you have not
yet entered any of the inverter UIDs.
Figure 23
Figure 24
Administration Tab
To Next Page
Loading...